Modelo: HJ-Series
Low-price fuel wood and coal hot blast furnace with CE certificate
Introduction of fuel wood and coal hot blast furnace:
Direct-fired hot-blast stove/furnace is made up of combustion chamber, settling chamber and mixing air chamber. Fuel is put into the combustion chamber manually. Under the effect of air blower, the fuel burns fiercely and produces high-temperature smoke with dust, which enters into the settling chamber to remove dust. Certain amount of cold air can mix with the hot air from the clean room, so hot smoke of different temperature can be offered. It can offer heat source for various kinds of drying systems.
Advantage of fuel wood and coal hot blast furnace:
1) the coal types of wide adaptability;
2) high combustion efficiency, thermal efficiency > 95%, if the quantity of heating fuel consumption such as the table;
3) output stable heat load, mechanical combustion, simple operation, adjustment is very convenient;
4) environmental protection standards, no secondary pollution, the operating environment is clean;
5) hot air spotlessness, dustiness 30 ~ 120 mg/Nm3.
6) convenient adjustment, hot air temperature below 1000 °C, + / - 5 °C continuous heating wind temperature stability;
7) equipment strong durability, low operating cost, simple maintenance.
Range of application:
Cleaning: detergent, the 4 a zeolite, the layered sodium silicate, detergent additives, etc
Ceramic: ceramic powder, glaze, clay, kaolin, etc
Fertilizer: compound fertilizer, monoammonium phosphate, diammonium phosphate, potassium chloride, magnesium sulfate, potassium sulfate, etc
Chemical categories: quartz sand, alumina, polyaluminium chloride, chemical additives, water purifier, ferric sulfate, etc
Building materials: ceramic fiber, insulation board, heat preservation cotton, ultrafine powder, gypsum, quartz sand, etc
Environmental protection: the sludge drying, papermaking black liquor and pharmaceutical waste liquid treatment, lignin, etc
The other: coal, wood drying, lees, food, feed, acetylene cylinder, rubber, silicone, paper plastic mould, dyes, etc
Parameters of fuel wood and coal hot blast furnace:
Model |
Heat Supply (kcal/h) |
Burning Area (Length*Width) |
Heating efficiency |
Coal Consumption (standard coal) |
HJ-20 |
20*104 |
0.6*0.7m2 |
≥90% |
30 kg/h |
HJ-40 |
40*104 |
0.8*1.0 m2 |
≥90% |
50 kg/h |
HJ-60 |
60*104 |
0.8*1.2 m2 |
≥92% |
70 kg/h |
HJ-100 |
100*104 |
1.0*1.4 m2 |
≥92% |
100 kg/h |
HJ-150 |
150*104 |
1.0*1.8 m2 |
≥92% |
150 kg/h |
HJ-200 |
200*104 |
1.2*2.0 m2 |
≥92% |
300 kg/h |
HJ-250 |
250*104 |
1.2*2.2 m2 |
≥92% |
400 kg/h |
Remarks |
Besides the above models, we can also supply special model as your request. |
Certification:
Welcome to visiting our factory!
Grupos de Producto : Calefacción de estufa de equipo > Madera y carbón, estufa de leña